Boat Cleaner Kit - 1L + Hose Foam Gun + Engine Flush Mixer Kit
HIGHLY CONCENTRATED: 1L MAKES up to 675 L at 1:675. ( That's about 600 Boat Washes / Litre! )
RECOMMENDED DILUTION: 1:250 to enable the Nano Protection. ( About 200 Boat Washes / Litre! )
Finally after so many requests from customers, our SALTY MUCK 1 Litre is now ready and available. This little Boat Cleaner Kit is the minimum you require to clean off all the salt and flush your motor after a good day out.
Package Includes:
1 x 1L SALTY MUCK Boat Cleaner, Salt Wash and Surface Protection
1 x Hose Foam Gun
1 x Engine Flush Mixer
Salty Muck safely removes salt and grime. It also leaves a water sheeting, protective coating.
It is Highly Concentrated and Biodegradable. Recommended dilution of 1:250 ( to enable the nano protection to be applied ), but can go up to 1:500 or higher.
Salty Muck is a low foaming cleaner with an active sheeting action to resist streaking and spots.
Use Boat Cleaner Kit on Boats, Kayaks, PWC’s, Trailers, 4x4's, Dive Gear, fishing tackle and surfaces exposed to corrosive salt.
Safe to use on any surface including aluminium, fiberglass, steel, magnesium, chrome, plastic and rubber. Use Salty Muck during regular maintenance and washes to increase longevity and function for years to come.
Contains: Plant derived surfactants & emulsifiers, antimicrobial preservatives, water sheeting agents.
APPLICATION and DILUTION:
NOTE: Test product on hidden spot to ensure compatibility, prior to application. No liability will be accepted.
Cleaning and Washing
For application using the Boat Cleaner Kit, use a recommended method below to apply a diluted ratio of Salty Muck to your boat or equipment. Agitate heavy grime if necessary.
- Hose Soap Gun: Use 20% Salty Muck with 80% water ( 200ml Boat Cleaner then fill container with water ), then set gun at
45 : 1 ( #1 on dial ) to get a 250 : 1 recommended ratio for regular washing + applying the nano protective coating. This will give you about 200 boat washes per Litre.
For heavier muck, set the dial to 25 :1 ( #2 on dial ) which will be 125 : 1 final ratio.
To get 675:1 ratio, use about 70ml Boat Cleaner in the empty container, fill with water, and use setting #1. This will give you about 600 boat washes per Litre.
2. Motomuck Snow Foam Gun for pressure washers: Use 10- 20 % Salty Muck with 80-90% water. Adjust the dial on the gun all the way to the right. Turn the dial towards the left if there are too many soap suds.
3. Mixer with spray nozzle: Use 100% Salty Muck in the reservoir cup.
Ensure you hose off all soap properly, with fresh water, before allowing the surface to dry.
Engine and Cooling System Flush
Use a Motomuck mixer: Attach the mixer to the garden hose, remove the reservoir cup, quarter fill with Salty Muck and reinstall. Connect to the flushing apparatus and turn on the water. Flush motor for 2-5 minutes.
Soaking gear and equipment
Mix 120ml of Salty Muck per 4 litres of water in a container. Soak gear or equipment. Rinse with fresh water.
HAZARDS AND FIRST AID
WARNING- Prolonged contact may cause mild skin irritation - rinse with water.
Irritant to eyes - Remove contact lenses, rinse with plenty of water.
Read label before use. Use only as directed. Keep out of reach of children.
If symptoms persist or feeling unwell after swallowed, seek medical advice or call the Poison Centre (NZ) 0800 764 766, (Australia) 13 11 26.
Have product label at hand. Dispose according to local regulations. Avoid release to the environment.
Care Instructions
After using the Gun to wash your vehicle, Motomuck highly recommends that you run some clean water through the Gun to ensure that it stays clean and free from any build-up of wash/foam concentrate, that can block the filter over time.